Standing Seam Roof Anchor Clamp with D-ring mount Aluminum Alloy Fall Protection Roofing Kit ANSI Compliant

WELKFORDER Standing Seam Roof Anchor Clamps are ANSI, and OSHA compliant. Alloy Aluminum and Steel Hardware.

• ANSI & OSHA Compliant: WELKFORDER Roof Anchor WFRA002 is ANSI Z359.1:2007 and ANSI A10.32-2012 compliant and in compliance with the requirements of OSHA 1926 Subpart M, 1910 based on basic fall safety principles incorporated into these standards, including hazard survey, hazard elimination and control. The primary intent is to ensure a proactive approach to fall protection.
• Safe & Non-penetrating design: WELKFORDER Roof Anchor WFRA002 will arrest falls and can be used as a single seam-single user device or as a component system. Construction consists of a D-ring anchor point and a solid aluminum anchor body to be attached with 12 stainless steel identical set screws. This standard anchor assembly includes a 5,000 lbs. ANSI compliant ring provides safe connection for fall protection equipment.
• Easy Installation & Use: WELKFORDER Roof Anchor WFRA002 is for use on steel standing seam panels, 24 gauge minimum thickness includes an interchangeable D-ring mount with bolts and washers included, and can be set-up easily within minutes. Compatible with an extensive use of connecting device of vertical lifelines, shock absorbing lanyard & self-retracting lifelines.
• Light weight & Resuable: WELKFORDER Roof Anchor WFRA002 is manufactured with aluminum alloy and stainless steel weighs less than 4.85lbs which is lightweight and can be easily transported between two different anchor position. WFRA002 is Resuable as part of the personal fall arrest system in order to minimize the impact on the worker in case of a fall.
• Warning: WELKFORDER Roof Anchor WFRA002 must be used by a Competent Person. Or the user must read and fully understand the limitations and proper use of the Fall protection equipment, and be properly trained by the Competent Person prior to use.WFRA002 must be positioned a minimum of 6’ from any fall hazard or roof edge. A minimum of 144 square feet of roof area is required for attachment.